You’ll definitely need to be handy to install this bracket for your microwave. Does look good after couple hours. Instructions need to be more specific.Looks nice and is well made, but the side width isn’t wide enough to completely cover the mounting clips. They show a little, not too bad but if you look close enough they can be seen.At first blush, this may seem to be very pricey for a microwave trim kit. However, there is more to the kit than just the exterior trim.1. This includes vent conversion hardware that is necessary when installing the microwave in a wall cabinet.2. This kit includes a mounting platform that the microwave rests on.3. Finally, the kit contains the SS trim that snaps on to complete the installation.This kit is well designed and engineered. However, the instructions are atrocious! They diagram 3 different installation options without describing the differences. All 3 diagrams have a typo (see photo) if you want a proper conversion from metric to imperial. No problem, one of my tape measures has both. It turns out that the recommended opening width of 600mm IS WRONG. I only discovered this after cutting the opening and installing the trim.... I have about a 3/16" gap on both sides. I plan on adding stainless steel angles to fix the appearance but better instructions from Panasonic are needed.PS: You should know that the installation instructions show a 1-1/2" gap in every shelf in the cabinet including the top. I am guessing that this allows the microwave to draw a proper volume of air in and to exhaust air out. I used a forstner bit to drill equivalent holes in every shelf and into the upper bulkhead. Again, the diagram shows this without explaining it in English.I had to do some remodeling of the kitchen cabinet opening to make this work, but the result is great. Very nice looking.The frame and associated parts were easy to install and looks great. Only issue was the amount of time it took to get this in.One of the very few 24” kits available. Looks great!